Build It Right.
Everything you need to bring your prints to life.
Quality hardware, trusted tools, and pro tips for the perfect build.
Hardware Kits
Curated kits for common builds
Insert Kit
- 25x 1/4-20 Inserts (Short)
- 10x M3 Heat-Set Inserts
Upgrade: Stainless Steel Upgrade available for $10 more
Fastener Kit
- 50x M3 Assortment Screws (Black)
- 20x M3 Locking Nuts
- 20x M3 Flat Washers
- 20x M3 Spring Washers
- 10x 6mm Metal Spacers
- 4x 1/4-20 Camera Screws
Complete Kit
- Everything from Insert Kit
- Everything from Fastener Kit
- Everything from Mag Kit
- Bundle & save!
Recommended Tools
Our top picks for quality builds
The Starter Iron
Perfect for beginners. Affordable and gets the job done for basic insert work.
The Pro Press
Vertical heat press station for precise, consistent insert installation. Worth it if you build often.
Insert Tips Set
Precision tips sized for M3 and 1/4-20 inserts. Essential upgrade for any iron.
Also Recommended
Digital Calipers
Measure twice, print once. Essential for verification.
View on Amazon →Hex Driver Set
M2, M2.5, M3 sizes cover 90% of builds.
Flush Cutters
Clean support removal without damaging prints.
Deburring Tool
Smooth out holes and edges for perfect fits.
Isopropyl Alcohol
Clean surfaces before adhesive application.
Best Practices
Pro tips for perfect builds
- Set iron to 220-250°C for brass inserts in PLA/PETG
- Let heat do the work - don't force the insert down
- Insert should sit flush or slightly recessed
- Wait 30 seconds before applying any load
- Use the right tip size for your insert
Pro Tips
Affiliate Disclosure: Some links on this page are affiliate links. We may earn a small commission at no extra cost to you. We only recommend products we actually use and trust.