Ummm... you can't buy your own design 😅
OSMODO 15mm Rod Adapter (Female)
FREE
Download at no cost
Verified Fit
Category
Mounts
Compatibility
OSMODO PRO, OSMODO
Difficulty
BEGINNER
Version
v1.0
Files Included
Female 1:4-20 15mm AdapterSTL • 514 KB
About this design
The OSMODO 15mm 1/4-20 Rod Adapter (Female) is a small 15 mm rod clamp with a female 1/4-20 thread built in. It is the counterpart to the male version and is perfect for catching 1/4-20 studs from arms, clamps, and other accessories.
It slides onto any standard 15 mm LWS rod. Tighten it down if you want a fixed position, or leave it slightly loose so you can slide it forward and back when you are adjusting balance or repositioning accessories.
It slides onto any standard 15 mm LWS rod. Tighten it down if you want a fixed position, or leave it slightly loose so you can slide it forward and back when you are adjusting balance or repositioning accessories.
Hardware
Recommended Print Settings
Material:PETG
Infill:40
Supports:none
Notes
Print on front or back side.
Hardware required: 1/4-20 metal insert, 10mm M3 screw, M3 locking nut. Place each nut into the captive hole on the bottom. Then screw the screw into the hole to tighten on your rod
Hardware required: 1/4-20 metal insert, 10mm M3 screw, M3 locking nut. Place each nut into the captive hole on the bottom. Then screw the screw into the hole to tighten on your rod
License
Personal Use
This design is licensed for personal use only. You may not share, resell, sublicense, rent, host, transfer, or distribute the digital files or any 3D printed versions. Commercial use requires explicit permission from the designer.
Comments (0)
to leave a comment
No comments yet. Be the first to share your thoughts!
